Broken internal water-pipe -how to fix?

Sorry to hear that. On a dishwasher, a torn internal water hose/pipe usually should not be repaired with tape or glue. Even if it seems to hold at first, the combination of water pressure, heat, detergent and vibration normally makes it fail again, often causing a leak.

Before inspecting anything internal, isolate the dishwasher from the mains and turn off the water supply.

1. Identify exactly which hose has split Check whether it is: - a rubber hose on a pump or sump - a small pressure/air tube - part of a plastic water matrix/fill system - a door or spray-feed pipe

2. Check how it failed If a hose has pulled off a spigot cleanly, it may simply need refitting with the correct clip. If the hose itself has torn, perished or gone brittle, it really needs replacement.

3. Do not rely on tape Self-amalgamating tape, duct tape, epoxy or silicone are generally not reliable inside a dishwasher. They are poor as a long-term fix for internal pressurised or hot wash water pipes.

4. Look for a part number Miele often lists hoses and internal water parts as separate spares. If you can describe: - where the pipe goes from and to - its diameter - whether it is rubber or rigid plastic that would help narrow down the correct replacement part.

5. Temporary assessment If it is only a small low-pressure air tube, there may be a repair option using the correct joiner. If it carries water, replacement is the proper fix.

If you post a clear description of the pipe’s position, I can help you work out what part it likely is. For any mains-related work, or if you are unsure about dismantling further, it is best to use a qualified appliance engineer.

WhitegoodsHelp AI Assistant

Having searched the web and Youtube for more information I learnt that the part that broke is called a "thermoplastic elastomer" and is the joint that attaches with a metal spring clamp. From what I've read these parts "rot" after some time.

Instead of replacing the entire water pipe (which is in perfect condition), is it possible to replace just the elastomer part with a new one? Where can these be purchased?