Blomberg WN-8428, 8Kg front load, F 08 ??
Hi guys, sure hope you can help me on this one! With the virus situation we're stuck at home and my wife is loosing it ...
Well, after completing a cycle and reloaded, my noticed that the machine is not responding.
Display is showing blinking "Play"sign (pause/play) and most of the other info is not showing
Program selector is not responsive either (nothing changes)
Unplugging for 20 Min did nothing
Found out on the net a procedure to turn it on while the program selector is at "12"and while holding the "Play/Pause"button and it turned on showing F 08. Also when pressing the "play/pause" at this stage shows C88 (Can be seen in attached video)
BTW I once knew a key combination to hold for a few seconds to reset the controller but I forgot it... does anyone know it?
I'm attaching videos of the display in normal Ön" and with the F-08 as I described above.
Any help on this would be very much appreciated!!!
Thanks and wish us all good health!
Dedy
Normal-on.mov On_with_puase_pressed.mov
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Blomberg WN-8428 unresponsive with F08 traced to door lock
- The problem
- Blomberg WN-8428 washing machine became unresponsive after completing a cycle and being reloaded. The display showed a blinking play/pause symbol, most other display information was missing, and the programme selector did not respond. A key procedure brought up fault code F08, and pressing play/pause at that stage showed C88.
- Likely cause
- Confirmed by the original poster as a faulty door switch/door lock.
- What fixed it
- The original poster reported solving the fault by replacing the door switch/locker. They also stated that clearing the code afterwards required holding the two buttons below the display marked with a lock symbol.
- Checks to try
- Machine unplugged for 20 minutes with no change
- Diagnostic key procedure displayed F08
- Pressing play/pause during that state displayed C88
- Parts or tools mentioned
- Door switch / door lock
2 Answers
Unfortunately I don't have any error codes for Blomberg. What's that high pitched noise, is that the washing machine and normal?
Need Professional Help or Spare Parts?
Hi Andy,
Thank you for your reply.
I have managed to solve this!
Just went over the most suspicious things, it was the door switch /locker
By the way, to reset the code after the replacement, you need to hold the two buttons below the display, marked with a lock symbol...
Best,
Dedy.
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Beko wmb 751441 error code F08
1 answer • 3 replies
wmfug942 F08
1 answer • 2 replies
Hotpoint Ultima Wt721 Fault Code F-08
1 answer • 16 replies
Old Blomberg machine motor?!
1 answer • 2 replies
Blomberg Green Plus - Leaking Bubbles & Washing Wet
1 answer • 1 reply
Blomberg drum seized
1 answer • 4 replies
Hoover Otsein Next 3650T/1-37 error E03
1 answer • 2 replies
Zanussi washing machine is not working & is displaying error code E91
1 answer • 1 reply
E18 fault
1 answer • 3 replies
Miele W5872 Fault F104 (low voltage to motor)
1 answer • 3 replies