Solved
AEG

AEG Washer Dryer making very loud banging noise at high spin

DJdjmidgley
Asked over 6 years ago 5,104 views
0

Hi washerhelp,

I hope you can help! Our AEG Washer/Dryer is make a very loud banging noise (Sounds to me like you can hear something bouncing around in the mechanics of it)

I've looked through the pinned guides in this forum and they state that it could be bearings however it says that you'd be able to replicate the sound by spinning the drum manually with your hand, i've tried and the sound only appears at the fastest spin in the cycle. I've uploaded a quick video of it to Youtube, i'd really appreciate if one of you lovely people could tell me your thoughts on what has gone wrong?

https://youtu.be/7QpZLY12cVg

If i've misunderstood the purpose of this forum I apologise!

Cheers!!

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

AEG washer dryer bangs loudly only at high spin

The problem
An AEG washer dryer was reported to make a very loud banging noise, described as something bouncing around in the mechanism. The noise could not be reproduced by turning the drum by hand and only occurred at the fastest spin.
Likely cause
The accepted reply says the sound suggests something is very loose. The most strongly supported possibilities mentioned were a loose component, the motor assembly, or a loose drum pulley. Bearings were considered by the owner from a guide, but the discussion does not confirm bearing failure.
What fixed it
Recommended action was to disconnect the appliance from the electricity, then check for anything obviously loose by shaking components carefully. If nothing obvious was found, the accepted advice was to remove the belt and listen to the motor spinning without the drum load, and to check whether the drum pulley where the belt fits was loose. The exact repair carried out was not confirmed in the thread.
Checks to try
  • Noise only happened at highest spin
  • Drum was spun by hand and the noise was not reproduced
  • Check for loose parts with the appliance disconnected
  • Remove belt and assess motor separately from drum
  • Check whether the drum pulley is loose

Safety: Disconnect the appliance from the electricity before checking for loose parts. Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 13 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

1 Answer

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered over 6 years ago

Hi. That’s a weird sound. Sounds like something is very loose. After making sure it’s disconnected from the electricity start shaking things about looking for something loose. You should be able to easily find something that’s as knackered as that. If not take the belt off the motor and see what the motor sounds like spinning when not turning the drum. Also make sure the drum pulley where the belt fits isn’t loose.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.