Reattaching the gasket on a Samsung WF 70F5E0Z4W
After some repairwork on my Samsung WF 70F5E0Z4W I have a problem that from what I could tell isn't covered by the washing machine help guide or by searching through the forum.
I am having trouble reattaching the gasket to the washing machine because: 1 The outer part of the gasket is glued to the front panel. 2 The area between where the gasket should go and the cement-block weights is about 2 cm. This combines to make is very hard to attach the gasket and to check the seal.
Using a pair of clamps to work my way from the bottom to the top by clamping, moving and camping Again seemed to work but water started to leak pretty fast during a short test run of the washing machine.
Do you fine folk have any advice, tip or suggestions for tools that might help me get the gasket in its proper place?
P.S: I can't take any photos of the washing machine right now but I'll try to get some posted this evening.
Edit: Forgot to add the full code of the machine, WF 70F5E0Z4W.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Samsung WF 70F5E0Z4W door gasket refitted after missed retaining band was found
- The problem
- After repair work, the door gasket on a Samsung WF 70F5E0Z4W was difficult to reattach. The outer part appeared glued to the front panel, access was tight near the concrete weights, and an initial refit leaked quickly on a short test run.
- Likely cause
- The outer seal retaining band had been missed during refitting, so the gasket was not secured and sealed correctly.
- What fixed it
- The retaining band on the outer seal was identified and fitted correctly. The poster then used a video guide and was able to seal the gasket properly.
- Checks to try
- Initial short test run showed a fast water leak
- Closer inspection revealed the metal retaining band on the outer seal
- Parts or tools mentioned
- Door gasket
- Metal retaining band
- Clamps
- Video guide
2 Answers
Thanks for the update. I was waiting for the photos :-) glad you managed it in the end. Changing the door seal can actually be very difficult these days. The difficulty varies from model to model and brand to brand. I remember the good old days when I could replace Hoover washing machine door seal in about 2 minutes flat.
Need Professional Help or Spare Parts?
WHOPS, I made a pretty big mistake. Somehow I missed the retaining band on the outer seal of the washer.
Had a closer look and finally noticed the metal band.
Using a video guide I was able to get the gasket sealed properly in about 5 minutes.
I'll leave the original post unedited unless ya'll think I should change it.
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Samsung AddWash WW10T654DLH turn on but freeze (calibration interruption also)
1 reply
Power button not turning on washing machine
2 replies
Samsung Ecobubble wd80j5410aw misterious problem
7 replies • Solved
Samsung Ecobubble not draining
4 replies • Solved
Samsung ecobubble keeps blowing the heating element.
26 replies • Solved
Samsung Ecobuble Washing Machine stops mid cycle
9 replies • Solved
Samsung auto dosing washing machine not dispensing softner
18 replies • Solved
Samsung EcoBubble (WW80J5555FX) - AC error and power issue
1 reply • Solved
Samsung Ecobubble will not finish the spin
1 reply • Solved
Creaking noise from Samsung Washing Machine when drum turning
1 reply • Solved