This old Zanussi Aquacycle 1200 is running through the complete cycles perfectly, except it is not heating the water at all.
I have changed ( unecessarily ) the element with combined temperature sensor. There is no voltage on the element when it should be heating.
The wires to the element appear to come from the pressure switch. The pressure switch has two connectors, a two pin and a three pin.
Water levels and everything else are working fine.
Any help greatly appreciated,
Dave
1 Answer
Hello Dave. When you say completes the cycle perfectly, do you mean it takes the normal amount of time and the laundry is clean when it comes out? What precisely is causing you to think the heater isn't working? Normally if the heating element isn't working washing machine should bring up an error code. There are anomalies where certain washing machines do not bring up an error code. But they usually exhibit some other unusual behaviour such as finishing the wash cycle much quicker, or taking much longer than normal.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Zanussi ZWD12270W heater element replacement
1 reply • Solved
Zanussi ZWH6160P Not heating Up
1 reply • Solved
Zanussi Cold Water Inlet Valve
2 replies • Solved
Zanussi washing machine is not working & is displaying error code E91
1 reply • Solved
Zanussi - problem with drum
3 replies • Solved
2006 Zanussi fill level too low
18 replies • Solved
Zanussi E52 Motor Tachometer Generator Fault
5 replies • Solved
Zanussi ZWF 5140P (Flexi Dose) sound while draining
1 reply • Solved
Zanussi Z716WT83BI
4 replies • Solved
Zanussi Z816WT85BI not running drying cycle - Need help with diagnostic mode please
6 replies • Solved