Zanussi ZWH7149P
Wonder if you could help please
I have looked through troubleshooting but cannot find an answer which matches my problem. The lights and individual LED's on the display flash frantically with no discernible error code and the machine will not run. I can resolve this by closing the door very, very firmly but more force is gradually being needed. Am I correct in suspecting the door interlock? If so could you point me in the direction of a good supplier and fitting instructions?
Many, many thanks
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Zanussi ZWH7149P flashing LEDs and only starts when door is pushed firmly
- The problem
- The washing machine display lights and LEDs flash rapidly with no clear fault code and the machine will not run. The problem can be temporarily cleared by shutting or pressing the door very firmly, and increasing force is reportedly needed over time.
- Likely cause
- Most strongly supported diagnosis is a door lock/interlock fault. The discussion also notes to check for a damaged door latch/catch or a door seal that has come away slightly and is preventing proper closure.
- What fixed it
- Recommended action was to inspect for anything stopping the door closing correctly, including the latch/catch and door seal. The accepted reply says the symptoms point to a door lock fault if pressing the door in makes it work. Spraying WD40 into the door lock and on the door catch was suggested in the thread, but no confirmed repair outcome was posted.
- Checks to try
- Machine works when the door is pressed in or shut very firmly
- Check whether the door latch/catch is damaged
- Check whether the door seal is slightly peeled away on the door frame and preventing closure
- Parts or tools mentioned
- door lock
- WD40
Safety: Do not bypass the door interlock. Further diagnosis should be carried out by a suitably qualified appliance engineer.
2 Answers
Hello. If pressing the door in gets the washing machine working then yes it sounds like a door lock fault. Just make sure nothing is preventing the door from closing properly such as a damaged door latch or the door seal slightly peeled away on the door frame. Try spraying some WD40 in the door lock and on the door catch. I have the largest stocks of washing machine spare parts available on my affiliate links all around the forum - Ransom Spares if you want to buy appliance spare parts.
Need Professional Help or Spare Parts?
This article explains in a bit more detail about the difference between genuine spare parts and non-genuine spare parts
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Zanussi washing machine is not working & is displaying error code E91
1 answer • 1 reply
Zanussi - problem with drum
1 answer • 3 replies
2006 Zanussi fill level too low
1 answer • 18 replies
Zanussi E52 Motor Tachometer Generator Fault
1 answer • 5 replies
Zanussi ZWF 5140P (Flexi Dose) sound while draining
1 answer • 1 reply
Zanussi Z716WT83BI
1 answer • 4 replies
Zanussi Z816WT85BI not running drying cycle - Need help with diagnostic mode please
1 answer • 6 replies
Zanussi ZW171201 stuck on 1 minute
1 answer • 1 reply
Zanussi Noise Filter
1 answer • 16 replies
Zanussi Z816WT85BI won't complete a load
1 answer • 6 replies