Zanussi Lindo 1000 stops mid cycle, no error code

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Zanussi Lindo 1000 stops early in cycle and jumps from 1 minute to end

The problem

A Zanussi Lindo 1000 washing machine starts a wash, then stops around 2 to 15 minutes into the cycle. The display briefly shows 1 minute, then 0, and the machine beeps as if the programme has ended. Water remains in the drum and the door has to be opened with the emergency release. After emptying and resetting, it may sometimes run one or two full cycles before the fault returns. No error code was reported.

Likely cause

The strongest diagnosis in the discussion is a heating fault, most likely an open-circuit heater. Forum replies state that if the machine washes initially but aborts after 10 to 15 minutes, the first suspect is failure to detect a temperature rise. This was not conclusively confirmed.

What fixed it

The accepted advice was that an open-circuit heater often causes this symptom. As no confirmed repair was posted, the thread supports diagnosis of a likely heating-system fault rather than a documented fix. Further diagnosis should be carried out by a suitably qualified appliance engineer.

Checks to try

• Observed that the machine fills and starts washing before stopping early
• Display changes briefly from 1 to 0 and beeps
• Water remains in the drum and the door requires emergency release
• Machine may work normally for one or two cycles before repeating the fault
• No error code was reported