Solved
Samsung

Samsung washing machine colour sheet

NMnmcilveen2016
Asked almost 7 years ago 3,999 views
0

I used a colour sheet last night in my wash, however on spinning it seems to have been sucked up into the door seal and cannot find it. I know its lodged somewhere in there as i seen it being sucked into the outer drum.

Thing is im worried in case this will cause lasting damage to my washing machine, any advice ?

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Colour catcher sheet drawn past door seal on Samsung washing machine

The problem
A colour-catching sheet was seen being sucked past the door seal into the outer drum area during spin, and the user was concerned it might damage the washing machine.
Likely cause
The sheet was small and thin enough to pass through the gap between the drum and the door seal. The accepted reply said the pump filter is the most likely place for it to end up.
What fixed it
The accepted advice was to check the pump filter repeatedly. The original poster then ran a few empty cycles to dislodge the trapped sheet and reported that this worked. To prevent a repeat, the poster said they would place the sheets in a mesh laundry net.
Checks to try
  • Observed the sheet being sucked into the outer drum
  • Ran a few empty cycles to try to dislodge it
  • Advised to check the pump filter
Parts or tools mentioned
  • Pump filter
  • Mesh laundry net
  • Colour-catching sheet
Confirmed fixedGenerated 5 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

4 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered almost 7 years ago

Check in the pump filter. Keep checking. That’s where it’s most likely to end up. Small sheets like that shouldn’t be used if they can go down the gap between the drum and door seal. I’ve seen it happen a lot with very small colour catching sheets. Bad idea.

Whitegoods Help — appliance repair expert and forum host.
1
NM
nmcilveen2016
Answered almost 7 years ago

Thanks for the advice. Done a few empty cycles to try and dislodge it and thankfully it worked, I will now put them in a mesh laundry net and have emailed the company Henkel who own dylon colour catcher regarding this also as they should be advising on their packaging that this clogging can happen and they unfortunately dont.

0
WH
WhitegoodshelpVerified Engineer
Answered almost 7 years ago

That's great. Thanks for the feedback. Essentially they are just too small and thin, and can get sucked down the gap between the drum and the back of the door seal on many washing machines. This gap is on every washing machine, but it does vary in size. Sometimes it is so small that it is very difficult or even impossible for things to go down but other times due to either poor design, or just the fact that the door seal has become worn, the gap is large enough to swallow these type of colour catches.

I could have sworn I had mentioned it in one of my article somewhere (but I can't find it at the moment) because the same thing happened to my washing machine when my wife used a colour catcher called Dr Beckmann. One jammed in our pump filter causing a breakdown. I would advise anybody using this type of product to have a look at the gap between the door seal and the lip of the drum. Slowly turn the drum around because the gap can vary at different parts of the drum. If there is an obvious gap that such a small item could go down then don't use them. Alternatively always try to put them in first rather than on top of the washing, or last, in the hope that they will stay deeper in the drum. Or as you have cleverly deduced, put them inside one of those laundry nets.

I think I might write a dedicated article about this and with your permission I will use your photo?

Whitegoods Help — appliance repair expert and forum host.
0
NM
nmcilveen2016
Answered almost 7 years ago

yea thats no problem, i hope the other ones ive been using havent got stuck in the pump without me realising

Your Answer

Sign in to share your expertise and post an answer.