F13 error
Hi. I have an indesit iwdd7143 washer dryer. When drying i get an f13 code lights flashing and machine stops, i have put a new thermostat in and the fan is spinning, clothes in the drum are hot so element heating up. Anybody got any ideas?
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Indesit IWDD7143 washer dryer shows F13 during drying
- The problem
- On an Indesit IWDD7143 washer dryer, the drying cycle stops with F13 and flashing lights. The user reported fitting a new thermostat, the fan was spinning, and the clothes in the drum were hot, indicating the heater was operating.
- Likely cause
- The accepted reply says F13 on several Indesit washer dryers points to a dryer-section NTC fault, though some explanations also include a possible fan motor fault. Based on the reported heating and the fault appearing after the dryer has run for a while, overheating was considered more likely, with a probable airflow blockage or possibly lack of cold water for condensing if the fan and NTC are not at fault.
- What fixed it
- Recommended action was to investigate the dryer-section NTC, confirm fan operation, and check for a blockage preventing air circulation. The accepted reply also suggested considering insufficient cold water supply for condensing. The exact repair carried out was not confirmed in the discussion.
- Checks to try
- New thermostat already fitted
- Fan reported as spinning
- Clothes in drum reported hot
- Fault occurs after drying has been on for a while
- Parts or tools mentioned
- Thermostat
- NTC thermistor
- Fan motor
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
Several Indesit washer dryers use F13 error code to indicate a fault on the NTC dryer section. I have an article on these parts here NTC thermistors. However, some of the F13 error code explanations are less also implicate a possible fan motor fault.
If the clothes are getting hot and the dryer gives the error code after it has been on for a while it tends to imply that it is overheating. But if the fan is running okay and the NTC is not faulty that really just leaves a potential blockage stopping the fan from circulating air or possibly even a lack of cold water to condense the hot steam.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Indesit IWDD7143 Express Wash&Dry fails with F13
1 answer • 1 reply
Indesit F13 error - Burnt fan
1 answer • 1 reply
Wdd960 F13 Fault
1 answer • 2 replies
Indesit Error F13
1 answer • 1 reply
Wdf740K F13 Error: Sensor Part Identification
1 answer • 7 replies
Aqm8F49U(Fr) Error: F13
1 answer • 15 replies
Hotpoint Wdd960 F13 Error Code
1 answer • 19 replies
Hoover Otsein Next 3650T/1-37 error E03
1 answer • 2 replies
Zanussi washing machine is not working & is displaying error code E91
1 answer • 1 reply
E18 fault
1 answer • 3 replies