Replacing hinge on Bosch Exxcel 8 VarioPerfect

Not that I can find but I'll dig around some more.

I've gone to the schematics on the Bosch website and there are 5 different parts; handle, hinges, glass, door surround & inner door but the only part that is sold by Bosch is the door and the only other parts I can find on other websites is a generic hinge that fits multiple models.

Hi Ross, did you solve the problem? I'm in the same predicament, so just wondering what you did? Many thanks

I have same problem, Drilled the top of the donut shape not going all the way through to the inner frame and it came apart. Got a new hinge on order for £8. Will let you know how i get on in a couple of days.

Hi Chamfer, did you manage to figure out what you had to do to get the new inner door trim to fit back on.

Was it a case of buying a new door then? Also, did you have to remove the metal spring around the rubber seal and fold the rubber seal in order to hold onto the back of the door hinge (as some videos suggest doing) - or you just unscrewed at the hinge and were careful to hold the door on the last screw? Thanks!

I was replacing a die cast hinge on my machine where a lug had snapped, located on eBay for approx £10-£15 depends on who you trust to go with....or Bosh direct for £20ish.

OK it sounded a bit traumatic whilst you do it but but the flat head screwdriver is the approach.

Remove the door from the machine (2mm star head screwdriver).

On the back of the door is a locating slot, use a flathead to prise off the facia. Work around the door, there are approx 10 sets of lugs. They are only ribs and so don’t snap, although it sounds like they are. Might be worth trying at the hinge area as this prized apart quite quickly. Once the fascia is away the 10 screws are revealed, and away you go.

The facia snapped back on easily

It took me about 20 minutes

Good Luck

AW

Just re-read the whole of this post

Bosch Serie 8 Washing Machines have multiple door types....mine was on the WAW28560GB/01 (same hinge as the GB/07)

My washer door is the same with a broken door hinge lug. I drilled the tops off the heat moulded lug tops (careful not to drill into the inside cover. The cover came away with ease. I did not have time to source a new hinge so I drilled a 5.2mm hole thro the hinge (where the lug had broken) tapped it M6 and fitted a pan head bolt with the thread portion protruding outwards 9.5mm (locktighted the thread) . popped on the plastic cap after wrapping a little PTFE tape over the thread. To refit the hinge I needed to cut away thin portion of plastic webbing to clear the bolt head.

Refitted the inner cover making sure the door latch was under the cover and drilled into retaining lugs with a 2mm diameter drill (not too deep). This is important to stop the lugs from splitting) I fixed the cover with thin wood screws and a washer. Success.

Yes it's annoying when they do that. You have to identify which one is for your model using the serial or production numbers

Yay! Great to hear Jimmy. Drilling the lugs is a good idea. I ended up prising them apart and the glueing them back togther but 2 years later the door is still going strong. All at the cost of a £10 hinge and some glue!