Hi,
I have a Bosch Logixx 8 washing machine that washes as normal, but when it is centrifuged it stops and the rinse lamp flashes.
If I try without clothes it spins as normal.
I have cleaned what can be cleaned.
Taken a reset.
Can it be the brushes?
Best regards
Frank H.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Bosch WAS28362SN spins empty but not with laundry; rinse lamp flashes
- The problem
- Bosch Logixx 8 Sensitive washing machine, model WAS28362SN, washes normally but stops during spin/centrifuge with the rinse lamp flashing when there is a load in the drum. It will spin normally when empty. The user had already cleaned accessible areas, reset the machine and confirmed it was level.
- Likely cause
- The strongest supported diagnosis is a load-balance/out-of-balance sensing issue. This is supported by the machine spinning empty but not under load, and by the user finding one of three wires to the balance sensor/vacuum side broken. Other possibilities mentioned in the discussion were a slack drive belt or PCB fault, but these were not confirmed.
- What fixed it
- No confirmed completed repair was documented. The practical action supported by the thread is to inspect the load balance system wiring and ensure the drum is loaded properly. The exact repair was not confirmed.
- Checks to try
- Machine reset carried out
- Accessible parts cleaned
- Machine confirmed level
- Observed that machine spins normally when empty
- Found one of three cables to the balance sensor/vacuum side broken
Safety: Do not bypass or remove the balance sensor. Further diagnosis should be carried out by a suitably qualified appliance engineer.
4 Answers
Normally if a washing machine spins ok without washing in but not with washing in the problem may be related to out of balanced loads Not spinning some loads
Other possibilities are carbon brushes (which is t applicable for you), a slack drive belt or a fault on the PCB.
Need Professional Help or Spare Parts?
Sorry for late reply. My notifications have been hit and miss. I've never tried to remove one. Make sure the drum is being loaded properly before suspecting the sensor.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Bosch WAN28150GB not spinning
6 replies • Solved
Bosch WM drains ok, begins to spin but stops
10 replies • Solved
HOW TO MAKE BOSCH BOSCH WAX32GH1GB PERFORM JUST A SPIN CYCLE
2 replies • Solved
Bosch Front Loader - Only Couple of Turns on Wash, Rinse or Spin Then Stops Turning
2 replies • Solved
Bosch Waq243 no spin
1 reply • Solved
Bosch spin speeds and differences between programs
3 replies • Solved
Bosch washing machine extending cycle at spin time
2 replies • Solved
Bosch 1600 Express Belt spindle noise
2 replies • Solved
Bosch 1400 express not reaching full spin.
5 replies • Solved
Bosch Exxcel 8 fails to rinse & spin
1 reply