Intermittent filling
Hello. I'm wondering if anyone can help please.
I have an LG direct drive (Inverter) machine, approx two years old.
When filling the machine, the fill stops and starts half a dozen times before continuously filling to the correct fill amount. My question is, why does the fill stop and start? It fills for a second or two then stops, then the same again and so on until filling as normal.
It has done this since new.
I don't think this is normal but any help appreciated.
Thanks, Mike
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Intermittent stop-start filling on LG direct drive washing machine appears normal
- The problem
- An LG direct drive (Inverter) washing machine, about two years old, stops and starts filling several times before then filling continuously to the correct level. The behaviour has been present since new.
- Likely cause
- The accepted reply says this is unlikely to be a fault because it has behaved the same way since new. The stop-start filling was described as normal operation, with the machine filling for several seconds while also energising the pump to flush through before starting properly. A poor connection on the water valve was mentioned only as a possible cause if repeated stopping developed as a fault, but this was not supported here.
- What fixed it
- No repair was recommended. The accepted advice was that the behaviour is normal and not likely to indicate a fault in this case.
- Checks to try
- Machine fills to the correct amount
- Behaviour has been present since new
- No change in operation over approximately two years
1 Answer
Hello Mike. If it's done it since the beginning and hasn't changed in 2 years then it seems unlikely to be a fault. It is normal for a washing machine to fill up with water for several seconds whilst energising the water pump to sort of just flush things through a bit before starting properly. Normally if it keeps stopping might indicate a poor connection on the water valve but you would have expected by now that it would have packed in properly was that.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
HJA8501 Washing Machine - Fills with water on every mode (Including when on a spin / drain cycle)
1 answer • 1 reply
Bosch WAE24061 keeps filling
1 answer • 2 replies
Samsung Ecobubble - cold water filling up drum on drying cycle
1 answer • 20 replies
2006 Zanussi fill level too low
1 answer • 18 replies
LG Washing Machine - working fine, except when trying to fill up with water.
1 answer • 1 reply
Hoover washing machine only fills with water on rapid 14/30/44 setting
1 answer • 3 replies
Filling washer with heavy wet clothes?
1 answer • 8 replies
Hot fill top loader
1 answer • 1 reply
drum is filling with dirty water overnight
1 answer • 7 replies
Washer Fills then stops ??? Help
1 answer • 12 replies
