Solved
Bosch

Bosch Wff 147S Drum Not Turning

RIRichardOwen
Asked about 15 years ago 2,594 views
0

Hi all,

The machine works perfectly except the drum doesn't turn. Water goes in, water goes out, the programme timer turns.

I've taken the top and back off and I can hear the relay switching to turn the drum motor on but no action. There's not even any attempt to turn the drum.

The belt's Ok. The motor turns freely by hand.

Any ideas as to where to start to look?

Thanks,

Richard

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Bosch Wff 147S drum not turning though wash cycle otherwise runs

The problem
On a Bosch Wff 147S washing machine, water fills and drains and the programme timer advances, but the drum does not turn at all. The drive belt was reported intact and the motor could be turned freely by hand.
Likely cause
The accepted reply says the main suspect is worn carbon brushes, if this motor is fitted with them. No confirmed repair result was posted.
What fixed it
Recommended starting point was to inspect the motor area for anything obvious at the motor plug and check for worn carbon brushes. The accepted advice was that an engineer would test the motor with a continuity meter, and if nothing obvious was found the machine should be referred to an engineer. The exact repair was not confirmed in the thread.
Checks to try
  • Drive belt checked and reported OK
  • Motor turns freely by hand
  • Relay could be heard switching for the motor
  • Visual check around the motor plug was recommended
  • Check for worn carbon brushes was recommended
  • Motor continuity test was recommended
Parts or tools mentioned
  • Carbon brushes
  • Continuity meter

Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 19 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

2 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered about 15 years ago

If the motor is fitted with carbon brushes they will be the main suspect. The first thing an engineer would do it test the motor with a continuity meter. If you can't see anything obvious around the motor plug, or detect worn carbon brushes you would be better calling in an engineer for this fault.

Whitegoods Help — appliance repair expert and forum host.
0
WH
WhitegoodshelpVerified Engineer
Answered almost 13 years ago

This article looks at all the possible causes of the drum not turning. Read both columns.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.