Beko Washing Machine Constantly Filling Even On Spin
Can anyone help? I put a load of washing on and when I went to unload the machine at what i expected to be the end of its cycle I found the machine had stopped before completion. I pushed the start button again and since then the machine is constantly filling with water even on the spin programme. I have tried the cancel button to reset the machine to rule out any programming error to no avail. What could the problem be?
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko washing machine constantly fills with water, even on spin
- The problem
- The Beko washing machine stopped before completing a cycle. After the start button was pressed again, it began constantly filling with water, including when set to the spin programme. Using the cancel/reset function did not change the behaviour.
- Likely cause
- The accepted reply says the fault could have several causes rather than one confirmed part. Examples mentioned were earth leakage on a component, the machine falsely detecting overheating due to a faulty NTC, or a main PCB fault.
- What fixed it
- No specific DIY repair was confirmed. The accepted advice was that the machine needs an engineer because the fault could stem from multiple electrical or control-related causes.
- Checks to try
- Tried the cancel/reset button to rule out a programming error
- Observed that the machine fills continuously even on the spin programme
- Noted that the machine had previously stopped before the end of a cycle
- Parts or tools mentioned
- NTC
- main PCB
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
2 Answers
It could be quite a few things really. You need an engineer I'm afraid for something like that. It could be anything from an earth leakage on a component, to it thinking it's overheating (faulty NTC) or the main pcb and so on..
Need Professional Help or Spare Parts?
Thanks for getting back to me
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies
Beko W/machine fills and drains immediately
1 answer • 1 reply
Beko WTB104R2A refusing to spin
1 answer • 5 replies
Beko Not spinning, only by hand
1 answer • 2 replies
Beko washing machine overfilling
1 answer • 2 replies
Beko WM74125W not filling with water, draining straight out
1 answer • 1 reply
Beko WMB714422W - keeps filling with water but stops when turned off
1 answer • 3 replies
beko Beko WM74125W makes banging noise after spin
1 answer • 4 replies
Cold fill Beko heats on cold wash too!
1 answer • 2 replies
Beko Wmb 81421 M not spinning
1 answer • 3 replies