Indesit Wib111 Anti-Crease And Door Lock Flashing

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Indesit Wib111 stops and flashes anti-crease and door lock lights

The problem

The Indesit Wib111 started a wash, appeared to take in a little water and detergent, then stopped with the anti-crease and door lock lights flashing. After this, the power light came on but the door would not lock and the cycle would not start. The filter and pipes were checked by the user, with no improvement.

Likely cause

A probable diagnosis in the discussion was F10, described as the pressure switch not sensing, with possible issues around the pressure switch or control module. This was based on the assumption that the flashing pattern corresponded to LED1 and LED3, but the exact light numbering was not fully confirmed.

What fixed it

The accepted advice was to identify the fault by the numbered flashing LEDs rather than the button names. Based on the assumed LED combination, the likely fault was F10. The only supported next step was to check connections related to the pressure switch and module. The exact repair was not confirmed.

Checks to try

• Checked filter
• Checked pipes
• Identified flashing anti-crease and door lock lights
• Considered LED numbering to interpret the fault code
• Advised to check connections

Parts or tools mentioned

• Pressure switch
• Module