Solved
Indesit

Indesit Wixe127 Replace Wire Connector

ADADarkDividedGem
Asked almost 14 years ago 3,720 views
0

Hi,

Our Indesit WIXE127 Washing Machine blew a fuse on the main fuse box and the plug itself. Once the fuses were replaced the door no longer locked itself. After removing the door seal and unscrewing the door interlock there was some obvious damage to both the lock and wire connector.

I am not worried about the door interlock as it can be easily replaced with the following part:

http://www.4washerhe...t.pl?pid=877127

However as you can see from the attached picture the connector is also damaged and wondered if anyone knew where I could buy a replacement?

Thanks,

Graeme

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Indesit WIXE127 door interlock and connector damaged after short

The problem
An Indesit WIXE127 washing machine blew the house fuse and the plug fuse. After the fuses were replaced, the door would no longer lock. On inspection, the door interlock and its wiring connector were visibly damaged.
Likely cause
The discussion supports a major short circuit at or around the door interlock area. A suggested possibility was water reaching the interlock, potentially from a damaged door seal, but this was not confirmed. It was also noted that another fault could have caused the interlock to fail, and printed circuitry elsewhere may also have been damaged.
What fixed it
Replace the damaged door interlock and obtain a replacement wiring connector via a parts request/special order. However, contributors advised not to assume the interlock alone caused the fault. The machine should be checked for underlying shorts with an insulation test meter before relying on the repair. The exact repair was not confirmed in the thread.
Checks to try
  • Visible inspection found obvious damage to the door lock and wire connector
  • It was suggested to check whether the door seal has holes near the door interlock area
  • It was advised that the machine needs checking with an insulation test meter for shorts
Parts or tools mentioned
  • Door interlock
  • Wiring connector
  • Door seal
  • Insulation test meter

Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 10 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

3 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered almost 14 years ago

Parts like that are usually impossible to buy without placing a special order. If you make a parts request at www.4washerhelp.co.uk they should be able to order one. However, damage like that is caused by quite a big short so I'd be cautious about just replacing the door interlock and connector without checking if something could have caused this problem in the first place. It really needs an insulation test meter on it to check for shorts. Maybe water got onto something and blew it? It's possible the door interlock did that on its own but it's also possible something else blew the interlock.

Whitegoods Help — appliance repair expert and forum host.
0
AD
ADarkDividedGem
Answered almost 14 years ago

Thanks, didn't realise you had a parts request form which I have now used and eagerly await a response.

I agree that this kind of damage might be a signal of a bigger problem. In the meantime I plan to replace the door seal and lock and start budgeting for a new washing machine.

Out of interest do you know of any guides or equipment needed to carry out an insulation test?

Graeme

0
WH
WhitegoodshelpVerified Engineer
Answered almost 14 years ago

Hi: Insulation test meters are only usually carried by repair engineers as they are too expensive. If the door seal has any holes in the side near the door interlock it's possible some water got onto the door interlock and shorted it out. It's also possible the short could have damaged printed circuitry elsewhere into the machine.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.

NAC Repair

Need an engineer?

NAC Repair

Rather leave it to a pro? Book a fully qualified engineer to diagnose and repair your Indesit.

  • Vetted, fully qualified engineers
  • Nationwide UK coverage
  • Fast, fixed-price appointments
Spares4Appliances

Need a spare part?

Spares4Appliances

Fix it yourself for less. Get genuine replacement parts for your Indesit delivered to your door.

  • Genuine, manufacturer-approved parts
  • Fast next-day UK delivery
  • Secure checkout & easy returns