Solved

Mould & Mildew Smelling On Clothes

DAdazmb
Asked almost 14 years ago 2,399 views
0

Hi Andy. I need your help/advice please. For the past two or three weeks I have had a reoccurence of what is usually a once a year problem (strangely always around this time of year @ early Autumn), with that problem being clothes that after an hour or so start to stink. Based on previous experience and what I read on your site and others that smell is caused by the heating up of the clothes releasing a rank mold/mildew odour that has been so bad I had to come home from work early today. I am getting headaches, my nose is running and eyes are watering. All signs I believe of mold spores that I am breathing in? In fact when I start to iron my clothes my nose is immediately starting to react. Worse I can actually sense other people sniffing and twitching there noses as I come near them! To say that I have not enjoyed the last two or so weeks at work is an understatement.... Today I went to the local laundry just to get some clothes cleaned.

The thing is Andy unlike previous years where as mentioned I have had this issue before this time I can't shift it. I've done everything I can to remove all visable mold on seals and in soap dispenser etc. It's totally self-inflicted as I'm your typical washing liquid user, influenced by instructions on bottle to do washes @ 30/40 degrees all year around (I should have learned my lesson really, but I have now - never again..).

To cure the issue this time I've done multiple 95 degree washes with soda crystals and white vinegar plus bleach once and also rubbed down the seal with surgical spirit which I read might help. The washing machine is about 4+ years old if I remember (a Zanussi), and as mentioned previous years doing all the above had cured the issue - simply finding mold in the visable part of the seal and removing it and doing a couple of 95 washes had sorted the problem. Do you think the fact that it isn't this time suggests there is a ton of gunk inbetween the seal and the drum that I can't see. Everytime I do a wash I am seeing new mold debris left in the water (and the water doesn't look to healthy either). All the mold is gone from the visable part of the seal except some 'surface' stains that don't seem to want to shift.

I am out of ideas now. The washer waste pipes connect to a U-bend in the sink at about 45 degree angle so I don't think any sink water is getting down into the machine or water is backing up around the S in the washer waste water pipe.

The mold spores in the clothes are making me ill after a couple of weeks, so if the machine needs replacing then so be it but I thought I'd ask you in case you had any remedy that might save what is mechanically still a good machine. Someone did mention to me using a descaler sloution would clear out all that hidden gunk, but said it might get in to the bearings and break the machine anyway (or something like that).

Any help much appreciated. It's hard to believe that your clothes washing could make you i'll !

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Washing machine causing mould/mildew smell on clothes

The problem
A 4+ year old Zanussi washing machine was repeatedly leaving clothes with a strong mould/mildew smell that became noticeable after wearing or ironing. The owner had cleaned visible mould from the door seal and dispenser area and had run several 95°C maintenance washes, but debris and dirty-looking water were still appearing and the smell was not cured.
Likely cause
The accepted reply said the machine was likely contaminated internally with mould/mildew, possibly throughout the tub and hoses, with ongoing moisture allowing it to persist. The exact internal source was not confirmed.
What fixed it
Recommended action was to keep the door open after use and also leave the soap dispenser open so the machine can dry out. For maintenance washes, use a detergent containing bleaching agents, and avoid delicates detergent, liquid detergent, or detergents marketed as gentle on coloureds. No strip-down repair or replacement was confirmed in the discussion.
Checks to try
  • Visible mould removed from the seal and soap dispenser area
  • Multiple 95°C washes had been carried out
  • Mould debris was still seen in the water
  • Waste pipe arrangement was considered and backflow from the sink was thought unlikely
Parts or tools mentioned
  • detergent with bleaching agents
Cause identifiedGenerated 12 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

1 Answer

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered almost 14 years ago

It sounds like you've tried everything. It may be the washing machine is covered in gunge inside all the tub and hoses, which isn't shifting. However, you seem to be having trouble with mould or mildew rather than gunge. Mould needs moisture so always leave the door open, even leave the soap dispenser open after use to allow it to dry out. I'm trying to think of ways the time of year could be relevant but can't think of anything.

Also, if doing a boil maintenance wash make sure you use detergent which has bleaching agents in it. Don't use delicates detergent, liquid detergent, or detergent claiming to be gentle on coloureds.

Mould in washing machines

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.

Need an engineer?

Find an Engineer

Rather leave it to a pro? Find a local engineer to diagnose and repair your appliance.

  • Search by your postcode
  • See the checks each business has passed
  • Compare ratings and call-out charges

Need a spare part?

Spare Parts Guide

Fix it yourself for less. Work out which part your appliance needs before you order anything.

  • Match the symptom to the likely part
  • How to find your full model number
  • When a genuine part is the safer choice