Candy Grand Vita 9KG - smoke and burning smell
My machine was on it's final spin and began making a noise I haven't heard before. Just as I went to switch it off it started to smoke from the back of the machine. Picture added for reference. The belt looks fine, though, any help would be great. You can see the area where the smoke has came from. Thanks in advance.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Candy Grand Vita 9KG smoked from rear during final spin
- The problem
- During the final spin, the washing machine made an unusual noise and then smoke came from the back. The belt was reported to look fine, with no visible damage or burned patch.
- Likely cause
- Most strongly supported diagnosis was a temporary drum obstruction or brief drum jam while the motor continued to run, causing smoke or burning from the rear area. This was suggested rather than confirmed.
- What fixed it
- The discussion did not confirm a repair. The original poster rebalanced the machine and re-centred the belt, but there was no follow-up confirming that this fixed the fault. The accepted advice was to remove the belt and check whether the drum felt noisy or stiff when spun by hand. As smoke was involved and no confirmed repair was documented, further diagnosis should be carried out by a suitably qualified appliance engineer.
- Checks to try
- Checked the belt visually
- Asked whether the machine had been noisy beforehand
- Advised to remove the belt and spin the drum by hand to check for noise or stiffness
- Asked whether the belt had any burned patch
- Original poster reported no issues with the drum
- Original poster rebalanced the machine and re-centred the belt
- Parts or tools mentioned
- Drive belt
Safety: Because the machine produced smoke and a burning smell, it should not be used again until properly checked. Further diagnosis should be carried out by a suitably qualified appliance engineer.
5 Answers
Has it been noisy? If you take the belt off and spin the drum by hand is it noisy or stiff?
Need Professional Help or Spare Parts?
Hi Andy,
No, there doesn't seem to be any issues with the drum. I've rebalanced the machine and centred the belt again. Thinking that I might try it again and see if that was all it was! What do you reckon?
Hi. Something must have happened. Therr might be an obstruction that temporarily jammed the drum.
Is there any damage on the belt like a burned patch?
Need Professional Help or Spare Parts?
Absolutely not a mark on the belt at all π€·ββοΈ
That would happen if the drum had jammed and motor continued to run. Are you sure the black is burn marks and not dirt or bits of rubber from the belt?
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Candy washing machine below slip
1 answer β’ 1 reply
candy rapido e20 (draining fault but washer drains fine)
1 answer β’ 6 replies
Candy RapidO - blocked filter?
1 answer β’ 13 replies
Candy Grand Vita, drum not moving
1 answer β’ 1 reply
Removing intergrated Candy washing machine filter
1 answer β’ 1 reply
Candy washing machine, opinion needed
1 answer β’ 1 reply
CANDY Machine repair advice - seeking an engineer
1 answer β’ 1 reply
Candy Washing Machine keeps putting in water when on
1 answer β’ 2 replies
Candy Alise fluff build up
1 answer β’ 1 reply
CANDY GRAND O'vita start stop button won't work
1 answer β’ 3 replies
