Zanussi Fla1002W Aquacycle 1000 -Drum Stopped Spinning
Hi, newbie here..... Was washing some towels tonight in my 11 year old washing machine, and near the end of the spin cycle the machine made some grinding noises, then the drum stopped spinning. After reading these forums I tried to troubleshoot a little bit -first putting a soggy towel (just one) in the drum and started the spin cycle. But again, the drum didn't move. After switching it off, I checked the drum movement by hand, and it does rotate but there is a slight resistance compared to when i have spun it round previously to check for the odd sock for instance. I could have put too much in the drum to start with, or else something has worn down. Any suggestions would be welcome. Cheers, Andy.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Zanussi Fla1002W Aquacycle 1000 drum stopped spinning due to failed drive belt
- The problem
- During the end of the spin cycle, the washing machine made grinding noises and the drum then stopped spinning. A test spin with a single wet towel also failed to turn the drum. By hand, the drum still rotated but with slight resistance.
- Likely cause
- Confirmed failed drive belt. The belt had worn down completely and split. A forum reply also suggested it may have become tangled around the drum pulley, which would explain the resistance, but that part was not directly confirmed by the repair.
- What fixed it
- The owner confirmed the fault was the belt but chose not to strip the machine down. A qualified engineer was called and fixed the problem.
- Checks to try
- Tried a spin cycle with one soggy towel and the drum did not move
- Checked drum rotation by hand and found slight resistance
- Advice given to inspect the belt from the back of the machine
- Owner confirmed the belt had worn down completely and split
- Parts or tools mentioned
- Drive belt
Safety: Machine should be disconnected before removing panels or inspecting the belt. Further diagnosis should be carried out by a suitably qualified appliance engineer.
5 Answers
It sounds like something could be stuck inside the drum. Take off the belt at the back to make sure you are only turning the drum as currently you are also turning the motor and theoretically it's possible for the motor to be the problem. It's also possible that the belt has come off and is tangled around the drum pulley at the back.
This article may help - how to remove something stuck in the drum although it's only a few tips to try and avoid stripping it down.
Need Professional Help or Spare Parts?
thanks for the reply. I don't wear a bra so i doubt if that's the cause of the drum not turning. It could be the belt though - is that difficult to get to do you think?
The article can help remove any object not just bra wires Belt is at the back. Just take back panel off or if there isn't one you'd have to try looking down with the lid taken off (and machine disconnected).
Need Professional Help or Spare Parts?
thanks for the reply. It was the belt - it had worn down completely and had split too. I was a bit unsure of taking the machine apart so I got a qualified engineer to fix the problem. It cost me, but at least i didn't have to worry about breaking something thru inexperience. As the engineer said, there's life in the ol girl yet. Didn't fancy forking out for a new machine, although I'll have to sooner or later....Thanks for sharing your experience on your great website!
Thanks for the update, normally when the belt comes off the drum spins much freer by hand but it sounds like it got tangled up in the drum pulley which accounts for the strange resistance.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Zanussi FLS1183W will not spin
1 answer • 12 replies
EU Zanussi F1232 NOT SPINNING
1 answer • 1 reply
Brand New Zanussi Zwf5140P Possibly Damaged And Not Starting Spin Cycle.
1 answer • 3 replies
Zanussi 1217W Not Spinning
0 answers • 3 replies
Zanussi Fls1383W Will Not Spin
1 answer • 4 replies
Zanussi Door Opens Whilst In Full Spin
1 answer • 2 replies
Zanussi Motor Not Spinning
1 answer • 1 reply
Zanussi Won't Spin After Tripping Electrics
1 answer • 4 replies
Zanussi No Spin
1 answer • 1 reply
Zanussi Spin Problem
1 answer • 3 replies