Hotpoint Motor
Need to replace a motor on a Hotpoint. Can it be done and how difficult is it. Any advice would be helpful . Thanks
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Hotpoint washing machine motor replacement is generally straightforward but model-dependent
- The problem
- The user asked whether a motor on a Hotpoint washing machine can be replaced and how difficult the job is.
- Likely cause
- No specific appliance fault or failed component was confirmed in the discussion beyond the intention to replace the motor. The main issue raised was that replacement motors can differ from the original depending on model, and some may require wiring changes.
- What fixed it
- Advice given was that motor replacement is usually simple in principle, with the motor commonly held by three bolts and connected by a plug. However, contributors stressed that the exact procedure depends on the model and that some replacement Hotpoint motors are not direct swaps. The accepted advice was to check the exact motor and any supplied instructions carefully, and verify whether the replacement is a direct swap before fitting. The thread did not document a confirmed repair on the appliance in question.
- Checks to try
- Confirm the exact Hotpoint model
- Check whether the replacement motor is a direct swap
- Check the motor plug orientation
- Check any instructions supplied with the replacement motor
- Parts or tools mentioned
- Replacement motor
Safety: Take care with motor wiring and plug orientation. If the replacement wiring arrangement is not clearly matched to the original, further diagnosis should be carried out by a suitably qualified appliance engineer.
2 Answers
As Edd says it depends on the model. In theory it should be extremely simple because there are usually just three bolts holding a motor in place. Then there is the motor plug which simply unplugs. However there can be tricky ones to deal with. I fitted Hotpoint motors which were different to the ones being replaced. Some even needed rewiring however, instructions should always be included. I've even seen motors where the motor plug could easily be plugged in upside down which would not be good. A good design should make this impossible though. Have a look on 4washerhelp to see if you can find your motor, there may well be a photo, or there may be instructions or a review that says whether it is a direct swap or not.
Need Professional Help or Spare Parts?
depends on the model and of course it can be done, I did mine. One tip would be to be very careful of the wiring. My motor was really wired for newer machines and the instructions stated to simply connect it as is into my older machine. I checked the wiring and it would likely have caught fire if I did that. I had to swap the wires around but it works brilliantly. Difficulty, well if you have any form of common sense, then it is really easy. You just unbolt the old motor, bolt the new one in place and adjust the belt tension. Then comes the wiring. The connector that you removed from the old motor, you can see which wires are for the tacho and the motor windings. Just make sure they will go to the same connections on the new motor. I had to cut 4 wires on mine and swap them around or 240v would have been issued to the tacho.
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hotpoint BI WMHG 81484 UK
1 answer • 2 replies
Hotpoint WMFUG942 Door Issue
1 answer • 1 reply
Knocking sound in vintage Hotpoint First Editions 1000 - suggestions please!
1 answer • 3 replies
hotpoint wmxtf 842 - Door Interlock screws
1 answer • 1 reply
Hotpoint WM51 motor armature query
1 answer • 3 replies
Hotpoint selling split tubs again?
1 answer • 7 replies
Hotpoint WD21 "Starter Edition" question
1 answer • 5 replies
Hotpoint rd966j screen not working
1 answer • 3 replies
Hotpoint Washing Machine spins but rubs
1 answer • 4 replies
Bleep from Hotpoint Washing machine
1 answer • 1 reply