Beko Wm611Nw - Washing Machine Tries To Start, But Cuts Out And Repeats.
I overloaded the machine, and they washed fine, but during the spin cycle the machine cuts out after a few seconds. It starts up after three or so minutes, but cuts out again without completing any program and it keeps doing this until I turn the machine off.
It will fill with water during the wash cycle however, but it will cut out and won't drain. I have to drain it myself.
The machine is only two years old so I'm not entirely sure what the problem may be.
There is a funny sound it makes, it sounds like the spin cycle is starting up, but then stalls and cuts out.
Any help would be appreiciated, thanks.
1 Answer
If there is a bad load in the machine (either underloaded or overloaded) most washing machines will keep trying to spin but may fail. Some may try for quite a while, stopping and starting, doing a slow spin then stopping, doing a spin but only at slow speed etc. If it's related to this it's all explained here - washer won't spin properly with certain loads in
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Can this washer be repaired?
1 answer • 1 reply
Beko YT124PT44MW no programme will run
1 answer • 1 reply
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Installing cover A underneath Washing Machine (Beko B5W1241AW)
1 answer • 5 replies
Beko tripping power plastic stuck in motor SOLVED
1 answer • 1 reply
Factory reset not working
1 answer • 1 reply
Beko - Shaking too much?
1 answer • 1 reply
Beko with inverter motor clicks when washing with water
1 answer • 4 replies
Beko wdix8543100 Not drying clothes
1 answer • 3 replies
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies