Beko do not end cycles
Hi I have problem with my Beko washer. When I start cycle and cycle is going to end my washer is draining water, but not ending cycle but start filling water again and again. I've checked thermistor but is ok, checked also pumps but also see good. On display I have error code 8119, but before I've had error code E1. Have you any suggest ?
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko washing machine repeatedly drains and refills at the end of the cycle
- The problem
- A Beko washing machine completes most of the programme, but when it reaches the end it drains and then starts filling with water again repeatedly instead of finishing. The user reported display code 8119 and previously E1. The thermistor and pump were said to have been checked and appeared OK.
- Likely cause
- The accepted reply suggested two possible explanations: siphoning causing the machine to fill and empty at the same time, or the control interpreting an overheating condition and entering a flushing cycle. The reply noted that overheating-related flushing would normally happen during the wash rather than only at the end, so siphoning appears the stronger suggestion. The reported codes were not recognised from the information available.
- What fixed it
- Check for a siphoning/drain hose installation issue and whether the machine is filling and emptying simultaneously. No confirmed repair was documented. If no installation fault is found, further diagnosis should be carried out by a suitably qualified appliance engineer.
- Checks to try
- Thermistor checked and reported OK
- Pump checked and reported OK
- Observed repeated drain and refill behaviour at end of cycle
- Error codes reported: 8119 and previously E1
Safety: Do not bypass any safety device. Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
Hello there. Is the washing machine doing a normal wash rinse and spin and leaving the laundry clean in the normal time? We need to work out if the washing machine is aborting the wash cycle at some point or whether it is working apparently perfectly okay but just developing an issue when it has finished the cycle.
One possible cause of a washing machine being stuck filling and training is siphoning, and other cause is the washing machine thinking it is overheating and going into a flushing cycle. However the latter is something that would happen during the wash cycle. Full details of these issues are on this article here - Filling and emptying at the same time
Other than that it is difficult to advise anything to check. The error code you mention is not a normal error code. I've never seen any error code as long as that and they normally have a letter such as E or F preceding them. However, the E1 error that you also quote is not in my book. I have very few error codes for the Beko brand unfortunately.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Can this washer be repaired?
1 answer • 1 reply
Beko YT124PT44MW no programme will run
1 answer • 1 reply
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Installing cover A underneath Washing Machine (Beko B5W1241AW)
1 answer • 5 replies
Beko tripping power plastic stuck in motor SOLVED
1 answer • 1 reply
Factory reset not working
1 answer • 1 reply
Beko - Shaking too much?
1 answer • 1 reply
Beko with inverter motor clicks when washing with water
1 answer • 4 replies
Beko wdix8543100 Not drying clothes
1 answer • 3 replies
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies