Beko WME 8227W
My machine stops mid cycle and the rinse symbol flashes. I've drained it, cleared out filters. It spins ok and finishes that. It rinses ok if just on a rinse. The problem seems to be when I put it in a full cycle - that's when it stops. It's a BEKO WME8227W
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko WME8227W stops mid-cycle with rinse light flashing
- The problem
- On a Beko WME8227W washing machine, full wash cycles stop part way through and the rinse symbol flashes. The machine will drain, spin, and complete a spin programme, and it will also rinse correctly when set to rinse only.
- Likely cause
- Most strongly supported diagnosis is no cold water available during the rinse stage. A faulty water inlet valve was also suggested as a possibility, but not confirmed.
- What fixed it
- Check that the cold water supply to the machine is actually on and supplying water, including that the tap has not been turned off. After confirming the water supply is OK, reset the machine using the Start/Pause/Cancel button. If the water supply is present and the fault continues, the exact repair was not confirmed in the discussion.
- Checks to try
- Drained the machine
- Cleared out filters
- Confirmed it spins and completes spin
- Confirmed it rinses on a rinse-only programme
- Check cold water supply to the machine
- Check the water tap has not been turned off
- Reset using the Start/Pause/Cancel button after confirming water supply
1 Answer
Hello Wendy. A flashing rinse symbol is virtually a universal sign of no cold water available for the rinses. Potentially though it could be a fault on the water valve but check that the cold water supply is actually supplying water to the machine. Make sure the tap hasn't been accidentally turned off. Use this troubleshooting guide for no water going into the machine and then try resetting the machine by pressing the «Start/Pause/Cancel" button for a short time after ensuring that the water supply is OK.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Can this washer be repaired?
1 answer • 1 reply
Beko YT124PT44MW no programme will run
1 answer • 1 reply
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Installing cover A underneath Washing Machine (Beko B5W1241AW)
1 answer • 5 replies
Beko tripping power plastic stuck in motor SOLVED
1 answer • 1 reply
Factory reset not working
1 answer • 1 reply
Beko - Shaking too much?
1 answer • 1 reply
Beko with inverter motor clicks when washing with water
1 answer • 4 replies
Beko wdix8543100 Not drying clothes
1 answer • 3 replies
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies