Solved
LG

LG f1443kd drain pump replacement

MAMancSki
Asked almost 10 years ago 4,073 views
1

This isn't so much a question as a repair report, hope that's appropriate.

I've spent the last couple of days exploring this machine which was making a very rough buzzing noise. Having decided that the problem was the drain pump (smelly water, washing wetter than expected, development of noise) I consulted youtube and various discussions for advice. There are quite a few vids and threads giving detailed instructions but all seemed to be discussing a slightly different model to mine and the disassembly for mine turns out to be much easier than most advice would suggest.

If like me you did a search for "LG drain pump" and have seen the LG disassembly vids that talk about removing the door seal and the front panel, pause briefly and check if you have a separate small (kick) panel at the bottom. If so there is no need to mess about with removing the lid, door seal and front panel. Just lever off the kick panel with a screwdriver and the white plastic box on the left (2 screws and slide to the right) to access the pump assembly.

You will find the 3 pipes held on with spring clamps, the smaller ones are easy enough to remove but the bigger one is a pig. Wide pliers or adjustable pliers are best.

Take a picture of the wiring before removing the wires (yeah, wise after the event).

Replacing the pumps is fairly straightforward and is well covered on Youtube but replacing that big pipe proved a proper struggle for me and is the main reason I decided to share. Take the spring clamp out, squeeze the tabs together and loop a cable tie over them to keep the spring under tension (opening the clamp), pull tight. Slip the clamp back over the pipe, re-attach the pipe and when you're happy with the position, cut the cable tie with a sharp blade, careful to avoid the pipe. The spring will close, holding the pipe fast.

This is a much smaller job than it first appeared but I only know that now as I've spent two days finding out.

The replacement motors (x2) are EAU61383505 which is a different part number to the old one 4681EA2001E(N) and other models shown on YT vids.

Respect to this site for ongoing help.

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

LG F1443KD rough buzzing traced to drain pump, access via lower kick panel

The problem
LG F1443KD washing machine developed a very rough buzzing noise, smelly water and wetter-than-expected laundry. The poster concluded the drain pump was at fault and reported replacing it.
Likely cause
Drain pump motor fault, supported by the noise, poor draining symptoms and the completed pump replacement report. This was user-diagnosed rather than independently tested in the thread.
What fixed it
Access was gained through the separate lower kick panel and adjacent white plastic box, avoiding removal of the lid, door seal and front panel on this model. The pump assembly was removed, wiring noted, and the replacement pump motors fitted. A cable tie was used to hold the large spring clamp open while refitting the larger hose. The accepted reply confirmed the clamp is difficult and is normally handled with a special tool or pipe pliers.
Checks to try
  • Observed rough buzzing noise
  • Noted smelly water
  • Noted washing was wetter than expected
  • Checked that this model has a separate lower kick panel for pump access
  • Took a picture of the wiring before removal
Parts or tools mentioned
  • Drain pump motors EAU61383505
  • Old pump marked 4681EA2001E(N)
  • Screwdriver
  • Wide pliers or adjustable pliers
  • Pipe pliers
  • Cable tie
  • Sharp blade
  • Special tool for the strong clip

Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 5 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

1 Answer

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered almost 10 years ago

Thanks for taking the trouble to join up and give others the benefit of your experience Mancski. The strong clip you mention has a special tool for removing. It can be handled with pipe pliers but it's usually very feisty and hard to keep under control without the proper tool. Good tip about using cable ties.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.

Need an engineer?

Find an Engineer

Rather leave it to a pro? Find a local engineer to diagnose and repair your LG.

  • Search by your postcode
  • See the checks each business has passed
  • Compare ratings and call-out charges

Need a spare part?

Spare Parts Guide

Fix it yourself for less. Work out which part your LG needs before you order anything.

  • Match the symptom to the likely part
  • How to find your full model number
  • When a genuine part is the safer choice