Solved
LG

LG washer dryer won't spin at full speed?

VJVjkdigital
Asked over 8 years ago 9,880 views
0

Hi all, WD1435RD washer dryer combo, rated at 1400rpm spin, but only spins up to 800rpm (as reported when SPIN button held while spinning).

I have the service manual and have entered service mode to test spin there, and it spins fine at 1400rpm from there, but not during a cycle or when set for spin only. Water level sensor frequency comes up as 255, manual says it needs to be above 248. As I expect it would not like to spin at full speed until the tub is completely empty.

I generally do all my own repairs on this machine but this one has got me stumped. I suspect there is a sensor out of specs somewhere that's telling the main not to use full spin speed. I've also tested at no load to confirm machine is not overloaded.

I'd appreciate any help as a call out is just too expensive for me on a low income.

Thanks Kym (new member)

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

LG WD1435RD only reaching 800rpm in normal use despite 1400rpm service test

The problem
LG WD1435RD washer dryer would only spin to about 800rpm during normal wash cycles and spin-only, even when 1400rpm was selected. In service mode, the machine was able to spin correctly at 1400rpm. The issue was reported on cottons, and happened most of the time, though it occasionally reached full speed.
Likely cause
The strongest diagnosis in the discussion is load-balancing behaviour rather than a failed drive system, because the machine could achieve 1400rpm in service mode and would sometimes reach full speed in normal operation. The forum replies suggested that full spin may only be allowed on certain programmes and when the load is correctly balanced; very small or empty loads may also prevent maximum spin.
What fixed it
No confirmed repair was documented. The accepted advice was to consider programme limitations, selected options, and especially load balance, as imbalance or under-loading can stop the machine reaching top spin speed. The exact repair was not confirmed.
Checks to try
  • Service mode spin test reached 1400rpm
  • Water level sensor frequency reported as 255
  • Tested on cotton cycle
  • Tested with no load
  • Observed occasional normal 1400rpm spin, but usually about 800rpm
Cause identifiedGenerated 4 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

3 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered about 8 years ago

Which wash cycle are you using? Only cottons is likely to do the top spin speed. Other wash cycles are likely to spin slower. Some option buttons might also reduce the top spin speed. Another thing that can prevent the top spin speed is if the laundry is not perfectly balanced. Sometimes if there is no laundry in the drum it won't do the top spin either.

Whitegoods Help — appliance repair expert and forum host.
0
VJ
Vjkdigital
Answered about 8 years ago

Using cotton cycle. One in five spins you can hear it spin up to 1400, the other four spins at 800, it's not overloaded as I've tried it with no garments at all and although it's showing 1400 it still only gets to 800.

0
WH
WhitegoodshelpVerified Engineer
Answered about 8 years ago

Some will only do full spin with a load in and only then if it’s perfectly balanced. Under loading is more likely to cause out of balance than overloading. The fact that it seems to do full spin sometimes but not others could mean it’s not managing to perfectly balance some loads. Either that or it’s a very tricky intermittent fault.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.