Solved
Beko

Beko wdx8543130w switches itself off

KEKen1659
Asked over 6 years ago 2,209 views
0

I have a beko wdx that turns itself off after running for a few minutes. I've put it into test mode and it just shows 15 I've tried searching for error codes and how to reset this model but can't find any info online.

Any help would be greatly appreciated.

Thanks

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Beko WDX8543130W switches off after a few minutes, motor fault suspected

The problem
Beko WDX8543130W washing machine runs for a few minutes then switches itself off. In test mode it initially showed 15, and after selecting a cycle in test mode it displayed E13.
Likely cause
Most strongly supported diagnosis is a motor-related fault. The accepted reply says to check the motor carbon brushes if fitted, as this is a very common cause of the motor not running. The exact cause was not confirmed.
What fixed it
Check the motor carbon brushes if the motor is fitted with them. The discussion does not confirm any completed repair or exact fix.
Checks to try
  • Entered test mode and saw 15
  • After turning the dial to a cycle in test mode, E13 was displayed
  • Wiring to the motor was visually checked
  • One blue and white wire to the motor was reported as getting no power
Parts or tools mentioned
  • motor carbon brushes

Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 12 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

2 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered over 6 years ago

My Beko error codes only go up to E12. Check the carbon brushes in the motor if it has them fitted. It's by far the most common cause of a motor not running.

Whitegoods Help — appliance repair expert and forum host.
0
KE
Ken1659
Answered over 6 years ago

quick update After turning the dial to a cycle in test mode it showed E13 which apparently is a motor problem I'm no electrician but I checked the wiring to the motor and found that one of the blue and white wires to the motor is getting no power the wiring in there is like spaghetti so I've not investigated further any idea if this would be an expensive fix?

Thanks

Your Answer

Sign in to share your expertise and post an answer.