Beko WTE 7512 BSS
Hello every body
I am using the model wte 7512 bss. It stopped executing all programs except "Rinse". I cleaned the water inlet and the outlet filter, but the problem persists. Can any one help? Thanks in advance.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko WTE 7512 BSS only runs rinse and spin
- The problem
- On a Beko WTE 7512 BSS washing machine, all programmes except rinse and spin stopped working. The user had already cleaned the water inlet and outlet filter. On wash programmes, the machine briefly takes in water, then drains for a few seconds, a harsh sound is heard, and the wash indicator blinks before the machine stops.
- Likely cause
- The strongest diagnosis in the discussion is a faulty main fill valve. A forum reply explained that the machine may first take in water from the rinse valve and pump it away, then switch to the main fill valve; if the main fill valve does not operate, the machine can show these symptoms while rinse and spin still work.
- What fixed it
- A diagnostic check was recommended to confirm whether the machine would begin washing once sufficient water was manually added through the soap dispenser. No completed repair or confirmed part replacement was documented in the thread, so the exact repair was not confirmed.
- Checks to try
- User cleaned the water inlet filter
- User cleaned the outlet filter
- Observed that rinse and spin still operate
- Observed brief fill, then drain, then harsh sound with wash light blinking
- Suggested check: add water through the soap dispenser during a wash programme to see if it starts washing
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
3 Answers
Sorry I missed this. Is it sorted now? When you say it stopped executing all programs does that mean it doesn't work on spin? What does it do when you put it on wash?
Need Professional Help or Spare Parts?
Thanks Andy. It executes only rinse and spin. When I put it in another program the machine starts to input water for just few seconds, then abruptly it stops this and starts to discard water for another few seconds and then a harsh sound is heard and the machine stops working with the wash indicator blinking.
When a washing machine starts it usually puts cold water in from the rinse valve and pumps it away, then after several seconds it energises the main fill valve. If the main fill valve is not working it may exhibit these symptoms and would work OK on rinse and spin. Try putting it on a wash and when it stops, add water into the soap dispenser drawer until the level gets to at least just below the bottom of the door glass to see if it starts washing once water is inside.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Can this washer be repaired?
1 answer • 1 reply
Beko YT124PT44MW no programme will run
1 answer • 1 reply
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Installing cover A underneath Washing Machine (Beko B5W1241AW)
1 answer • 5 replies
Beko tripping power plastic stuck in motor SOLVED
1 answer • 1 reply
Factory reset not working
1 answer • 1 reply
Beko - Shaking too much?
1 answer • 1 reply
Beko with inverter motor clicks when washing with water
1 answer • 4 replies
Beko wdix8543100 Not drying clothes
1 answer • 3 replies
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies