I have bought and replaced the shock absorbers and also bought the 4 drum springs from Miele to change as well while I'm at it as the machine is 12+ years old and in good condition other than the shocks failing a while ago. I have opened up front side of washer and am intending to remove soap dispenser and attendant hoses for access to left side springs. Is there a special tool/knack for removing/replacing the springs. Do I have to lift the drum with ratchet strap to replace springs in which case can the door seal be left in place...
5 Answers
Sorry, those springs are so strong I’ve never heard of anyone replacing them.
Need Professional Help or Spare Parts?
I would try laying it down on its side so you can slide the drum without having to lift it.
Need Professional Help or Spare Parts?
The door seals will allow a lot of movement. It’s also too strong to damage by stretching. Should only need to disengage it if you needed to move outer drum quite a long way. Should just peel off the door frame though. No need to actually remove it.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Miele WEG365 WCS: drain fault and pump cavitation after transport - looking for W1/PowerWash expertise
2 replies
Miele WT945 - no water going into drum
1 reply • Solved
Miele WWI660 water under machine.
1 reply • Solved
Miele WT945 discharges water into bottom of machine from lower condenser hose after final spin?
13 replies • Solved
Tension springs on Miele W2243
17 replies • Solved
Miele W5872 Fault F104 (low voltage to motor)
3 replies • Solved
Miele WKG120 Twindos leaking intake
1 reply
Miele WD2780 Fault 53
4 replies • Solved
Miele Prestige Plus washing machine: 'Check Inlet' light flashing.
5 replies • Solved
Miele Washing Machine (Spinning Noise)
4 replies • Solved