Access To Pcb On Beko Wma 510W
Can anyone tell me how to access the PCB on a Beko WMA 510W machine?
The fault is :- It started being unreliable at spinning on the main cycle, then it was unreliable at spinning on the rinse and drain cycle. Now it just takes in water, rotates for about 5 minutes, then stops, leaving me with dirty, soap slimed soaking washing! I think I need to change the PCB, but can't see how to access it.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko WMA 510W stops after filling and brief drum rotation
- The problem
- A Beko WMA 510W became increasingly unreliable on spin during the main cycle, then on rinse and drain, and eventually only filled with water, rotated for about five minutes, then stopped, leaving the wash unfinished. The user suspected the PCB and asked how to access it.
- Likely cause
- The PCB was only suspected by the user. The accepted reply states PCB faults are often misdiagnosed, so the actual cause was not confirmed from the discussion.
- What fixed it
- No repair procedure was provided. The accepted advice was not to replace the PCB speculatively, as this would be a gamble without proper diagnosis. Further diagnosis should be carried out by a suitably qualified appliance engineer.
Safety: Do not replace the PCB speculatively without confirming the fault first.
1 Answer
I hope not to offend but I if you don't even know what a part looks like or where it is it might be better not to try and replace it. You cannot get guarantees with parts such as the pcb because they are so often misdiagnosed as the culprit so it would be a speculative gamble replacing it because it's not certain to be the cause of the fault.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Can this washer be repaired?
1 answer • 1 reply
Beko YT124PT44MW no programme will run
1 answer • 1 reply
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Installing cover A underneath Washing Machine (Beko B5W1241AW)
1 answer • 5 replies
Beko tripping power plastic stuck in motor SOLVED
1 answer • 1 reply
Factory reset not working
1 answer • 1 reply
Beko - Shaking too much?
1 answer • 1 reply
Beko with inverter motor clicks when washing with water
1 answer • 4 replies
Beko wdix8543100 Not drying clothes
1 answer • 3 replies
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies