Beko Wm5100W - How Do I Replace Drain/waste Pipe
Hi there
Our Beko WM5100W has a badly torn waste pipe
I've found replacement waste pipes online but i'm struggling to understand how i go about removing the broken one from the back of the washing machine.
It sounds simple enough but i cant grasp how, I'm confident with taking it apart depending on how much of it has to be disassembled..
I'm attaching two pictures of the back of the washing machine , hopefully this helps?
Any help would be very much appreciated.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Beko WM5100W torn drain hose replacement access
- The problem
- The washing machine's waste/drain hose was badly torn and needed replacing. The query was how to remove the damaged hose from the back of the Beko WM5100W.
- Likely cause
- Confirmed physical damage to the drain/waste hose. The accepted reply states the hose connects internally to the water pump with a hose clip.
- What fixed it
- The accepted advice was that the drain hose passes into the machine and is secured to the water pump by a hose clip. Remove the back panel to access it; if access is poor from the rear, fully disconnect the appliance from the power supply and fill hose and lay it on its front to reach underneath. The exact completed repair was not confirmed in the discussion.
- Checks to try
- Remove the back panel and inspect where the drain hose enters the machine
- Check the hose connection at the water pump
- If rear access is limited, access from underneath after disconnecting power and fill hose
- Parts or tools mentioned
- Replacement waste/drain hose
- Hose clip
Safety: Disconnect the appliance from the power supply before moving it or accessing underneath. Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
The drain hose just goes into the machine and is attached to the water pump with a hose clip. With the back off you should be able to see, it should be very straight forward. If you can't get proper access from the back you might need to completely disconnect it from the power and fill hose and lay it over on its front to get underneath.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Washing Machine Beko B5WT594189W drain hose dissappeared behind filter panel
1 answer • 1 reply
Beko WM5100 stops after wash- no rinse or spin/drain- but will rinse and spin/drain separately
1 answer • 12 replies
Beko strange noise, not draining
1 answer • 3 replies
Beko WTL82051W - Not draining, including from emergency hose.
1 answer • 1 reply
Beko not draining, engineer stumped
1 answer • 5 replies
Beko W/machine fills and drains immediately
1 answer • 1 reply
Beko WTG721M1B washing machine drain pump
1 answer • 13 replies
BEKO WDX8543130W Not Draining
1 answer • 3 replies
Beko WM74125W not filling with water, draining straight out
1 answer • 1 reply
Beko WM7127w wont drain - ordered a pump.
1 answer • 18 replies