Hello everybody
Got a problem with the above
Turn to program C turn on and machine starts to fill for a bout 10-12 seconds then stops
Ive checked filter on solenoid valve ive treid different programs but same syptoms any ideas?
thanks
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
WMF 720 fills briefly then stops
- The problem
- WMF 720 washing machine starts a programme, fills for about 10-12 seconds, then stops. The same symptom occurs on different programmes. The inlet valve filter was checked.
- Likely cause
- The accepted reply says the brief initial fill can be normal as part of the sump hose sealing process, and that a faulty main fill valve is the strongest suggested cause if the machine then stops instead of continuing to fill. A secondary possibility mentioned was that the machine is detecting another fault and aborting the cycle, but no error indication was reported.
- What fixed it
- Recommended action was to check the main fill valve first. If the stop is due to another detected fault, further diagnosis would be needed, but no specific confirmed repair was given in the discussion.
- Checks to try
- Checked filter on solenoid valve
- Tried different programmes with the same symptom
- Parts or tools mentioned
- Main fill valve
- Solenoid valve filter
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
Most washing machines fill with cold water for several seconds to flush water into the sump hose which then gets sealed off by a floating ball inside the sump hose. Then the main fill valve is energised which flushes the detergent into the drum. This process prevents detergent being flushed into the sump hose and getting wasted.
If the main valve is faulty it could account for it flushing water for a short while and then stopping. I'd check that first. The other possibility is that it's nothing to do with water or the valve and the machine is detecting a fault somewhere and aborting. However, if this is the case I would expect it to pump out the water, turn off after a short while and flash some lights to indicate an error code.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hisense washing machine not working
1 reply
No water in the drum after EF3 fault
4 replies
Hisense washing machine 001 code
6 replies
LG F1222TD PCB
5 replies
Bosch series 6 washer / drier stuck on 0.00 time and will not respond to any button
1 reply
Miele WEG365 WCS: drain fault and pump cavitation after transport - looking for W1/PowerWash expertise
2 replies
Water leaking from drain filter
1 reply
Water leaking from drawer of Meile washing machine
1 reply
Bosch washing machine only spins sometimes
2 replies
Hoover Wsahing Machine NOT filling with ENOUGH water
3 replies