Solved
Beko

Beko Wm95135Lb Won't Fast Spin On Spin And Drain Cycle!

PUPughey88
Asked over 11 years ago 9,297 views
0

My beko wm95135lb is 14 months old. For some reason, once it gets to the spin and drain cycle, it spins for about 2 mins, then the timer resets itself by 2 mins, and it repeats the process. The clothes are coming out soaked (but not wet enough that they can be wrung out)

Any ideas? There's no issue with drainage because during the was cycle the water drains fine. No idea what it could be! HELP!

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Beko WM95135LB will not reach fast spin with clothes in the drum

The problem
A Beko WM95135LB, about 14 months old, would get to the spin and drain stage, attempt to spin for around two minutes, then stop and add two minutes back onto the timer repeatedly. Laundry came out soaked. The owner reported that the machine could fast spin correctly on an empty maintenance wash, but not when clothes were inside.
Likely cause
The discussion most strongly suggests the machine is failing during the load distribution stage before high-speed spin. Probable causes mentioned were a blocked pump or a blocked or faulty pressure system, though other causes were also noted and no single fault was confirmed.
What fixed it
No confirmed repair was posted. The recommended action was to check whether the machine was only slowly revolving during the pre-spin distribution period and, if the issue persisted, arrange for an engineer to diagnose it.
Checks to try
  • Observed that the machine repeated a two-minute spin/drain attempt and reset the timer
  • Confirmed the machine could fast spin with no clothes in the drum
  • Considered whether the drum was only revolving slowly during the distribution period before full spin

Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 11 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

3 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered over 11 years ago

When you say it spins for 2 minutes do you mean spins, or do you just mean it revolves slowly? Reply depends on this clarification.

Whitegoods Help — appliance repair expert and forum host.
0
PU
Pughey88
Answered over 11 years ago

HI

The Machine attempts to spin for 2 minutes, and then it stops and resets. It has the capability to spin as i have put a wash on with no clothes in with limescale remover inside and it spins fast as it should. its only with clothes in when it has trouble.

Thanks

0
WH
WhitegoodshelpVerified Engineer
Answered over 11 years ago

Hello, before a full spin there is a distribution period where the drum should revolve slowly for a couple of minutes trying to settle the load into a nice balanced load. If it does this first but then instead of kicking into a big spin just clicks and turns off then a blocked pump, or blocked or faulty pressure system could be the cause. There are other causes too.

This is the article you need to read carefully to get a better idea. If it doesn't help the best thing is to get an engineer - won't do the fast spinHello, before a full spin there is a distribution period where the drum should revolve slowly for a couple of minutes trying to settle the load into a nice balanced load. If it does this first but then instead of kicking into a big spin just clicks and turns off then a blocked pump, or blocked or faulty pressure system could be the cause. There are other causes too.

This is the article you need to read carefully to get a better idea. If it doesn't help the best thing is to get an engineer - won't do the fast spin

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.