interlock modification to the block connector.
hello please welcome me with open arms to this community.
I have a problem with replacing the new type of door interlock onto the old type door interlock block harness as they is obvious mismatch.however been told to adjust the interlock block connector.even with diagram provided it still does not add up. there are five wires in the harness vs 3 wires in the diagram that was provided.
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Replacement door interlock does not match existing 5-wire harness
- The problem
- The washing machine owner was trying to fit a new-style door interlock to an older block connector. The existing harness had five wires, but the supplied diagram only showed three, so the wiring change did not make sense.
- Likely cause
- The accepted reply indicates the replacement interlock is probably the wrong part, or at least not a clearly compatible substitute for the machine’s original door interlock.
- What fixed it
- Check the appliance model number and confirm the exact correct replacement door interlock part. If the part is genuinely correct, the supplied leaflet should clearly explain any approved connector modification. No confirmed wiring alteration or completed repair was documented.
- Checks to try
- Compared the existing 5-wire harness with a diagram showing only 3 wires
- Noted that the new interlock looked very different from the old one
- Advised to verify the replacement part against the machine model number
Safety: Do not bypass or modify the door interlock wiring unless the replacement part and fitting instructions are confirmed correct. Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
It doesn't sound like a proper replacement if it looks very different and 2 wires are not used. You have to make sure you have the right replacement part. If you do then the leaflet should explain exactly what to do. Can you find the part you need on Ransom Spares using your model number and see if it's the same as the one you've bought?
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hotpoint WMFUG942 Door Issue
1 answer • 1 reply
Front Load Washer Rubber Door Seal Not Aligned? Whirlpool WFW560CHW
1 answer • 1 reply
hotpoint wmxtf 842 - Door Interlock screws
1 answer • 1 reply
Door seal holding water
1 answer • 7 replies
washing machine door locks
1 answer • 11 replies
Rubber fire after replacing door seal
1 answer • 1 reply
Bosch 1400rpm (2009) door won't open
1 answer • 3 replies
Bump in rubber door seal - samsung series 5 ecobubble
1 answer • 1 reply
Hotpoint door won't lock
1 answer • 3 replies
Whirlpool dreamspace washing machine door seal
1 answer • 6 replies