I put a lot of clothes in the washing machine and because of this the washing machine try to spin but didn't succeed to spin and this make a short circuit that make the big cylinder that have inside all the clothes to don't turn but the water inside and outside of the washing machine continue to work so now the motor don't rotate the big cylinder that inside there are the clothes
I think that the fuze that charge of activate the motor that rotate the big cylinder with the clothes inside was burn
my problem is that I don't know where is this fuse located inside the washing machine so I take some pictures of the washing machine and I hope one of you can tell me where is this fuse, how I can check this fuse and change it
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Drum not rotating after overload; internal fuse not identified
- The problem
- After the machine was overloaded, it tried to spin but failed. The drum then stopped rotating, although water functions continued to operate. The user suspected a fuse for the drum motor had blown and asked where it was located.
- Likely cause
- The accepted reply states there is not usually a fuse inside a washing machine for this fault. The most strongly supported diagnosis is that the motor may have caused damage to something on the main PCB. The exact failed component was not confirmed.
- What fixed it
- No internal motor fuse location was identified because the accepted answer says there usually is not one. The recommended action from the discussion is to consider a fault on the main PCB rather than looking for a separate fuse. The exact repair was not confirmed.
- Checks to try
- Observed that the drum would not rotate
- Observed that water functions continued to work
- Advised that if a fuse were present it would usually be an obvious glass fuse with a visible wire
- Parts or tools mentioned
- main PCB
- glass fuse
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
Hello. There isn't usually a fuse inside a washing machine. The motor could have have blown something in the main PCB. If there was it would normally be an obvious fuse, usually made of see through glass where you could see the small fuse wire.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hisense washing machine not working
1 reply
No water in the drum after EF3 fault
4 replies
Hisense washing machine 001 code
6 replies
LG F1222TD PCB
5 replies
Bosch series 6 washer / drier stuck on 0.00 time and will not respond to any button
1 reply
Miele WEG365 WCS: drain fault and pump cavitation after transport - looking for W1/PowerWash expertise
2 replies
Water leaking from drain filter
1 reply
Water leaking from drawer of Meile washing machine
1 reply
Bosch washing machine only spins sometimes
2 replies
Hoover Wsahing Machine NOT filling with ENOUGH water
3 replies