Solved

Cycle normal but clothes still wet

AMAmyr1600
Asked almost 6 years ago 6,130 views
0

I have a year old beko washing machine (WTB820E1W). It runs the cycle normally and spins at the end but the clothes come out wetter than they should. If I then do an extra spin and drain cycle the clothes come out as they should. Why is this happening? I've checked the filter, hoses and even cleared the drain pump but still no change. Please help! Very frustrating!

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Beko WTB820E1W leaves clothes wetter than expected on some cycles

The problem
A one-year-old Beko washing machine, model WTB820E1W, completed wash cycles and spun at the end, but clothes were coming out wetter than expected. Running a separate spin and drain afterwards produced a normal result. The owner had noticed a longer wash programme worked normally.
Likely cause
The strongest diagnosis in the discussion was either use of a programme with a lower or shorter final spin, or a drainage restriction slowing water removal enough to reduce water extraction on the final spin. An out-of-balance load was also suggested, but this was not confirmed. Worn motor brushes were mentioned by another member, but the owner reported the spin sounded totally normal, so that explanation was not supported.
What fixed it
Checks focused on confirming the selected programme includes a full final spin and looking for any partial drainage restriction. The owner reported checking the filter, hoses and drain pump, and later said a longer wash worked fine. No exact repair was confirmed in the thread.
Checks to try
  • Checked the wash cycle selection
  • Checked the filter
  • Checked hoses for blockage
  • Cleared the drain pump
  • Observed that an extra spin and drain leaves clothes normal
  • Observed that a longer wash worked fine
  • Confirmed the spin sounded normal
Cause identifiedGenerated 11 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

6 Answers

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered almost 6 years ago

If the laundry hasn't had enough water extracted from the spin first thing is to doublecheck it is on the correct wash cycle that has the full spin at the end. Some wash cycles will not do the fast spin at the end. In fact only the cottons wash cycle usually does.

If it is definitely on a wash cycle that has the fastest spin at the end then if the laundry is uneven or out of balance the washing machine may never reach full spin speed, or it may only spin at top speed for a short time before abandoning it - Won't spin one item or small loads

The only other thing I can think of is a partial blockage in the drain hose or at the U bend under the sink (if it drains into there) that is just restricting the rate of water flow out of the pump enough to interfere with water extraction which is rectified after the second spin (Can't find a blockage but washing machine still not draining properly).

Whitegoods Help — appliance repair expert and forum host.
0
AM
Amyr1600
Answered almost 6 years ago

Thank you for your response. I checked all you suggested and still no change. I did a longer wash and that worked fine. I just find it weird that the clothes were coming out normally with the previous cycle and now it's not. But appreciate you taking the time to give your advice

0
WH
WhitegoodshelpVerified Engineer
Answered almost 6 years ago

Does it sound totally normal on spin? If it’s making a crackling or creating sound it could be the motor brushes are worn (if fitted)

Whitegoods Help — appliance repair expert and forum host.
0
AM
Amyr1600
Answered almost 6 years ago

Totally normal

0
WH
WhitegoodshelpVerified Engineer
Answered almost 6 years ago

I can only say that if it’s spinning normally and for the normal amount of time then unless there’s a partial blockage somewhere restricting how fast the water can pump out there’s no there’s no other explanation I can think of.

Watch it carefully when it goes into the final spin. If there’s a lot of soap detergent being thrown around when it first goes into spin that’s a sign it’s not draining properly or fast enough.

Whitegoods Help — appliance repair expert and forum host.
0
AM
Amyr1600
Answered almost 6 years ago

Thank you. I have removed all the hoses and checked they're clear, checked the filter, and cleared the drain pump. If nothing else I'm now educated on where everything is in a washing machine!

Your Answer

Sign in to share your expertise and post an answer.

NAC Repair

Need an engineer?

NAC Repair

Rather leave it to a pro? Book a fully qualified engineer to diagnose and repair your appliance.

  • Vetted, fully qualified engineers
  • Nationwide UK coverage
  • Fast, fixed-price appointments
Spares4Appliances

Need a spare part?

Spares4Appliances

Fix it yourself for less. Get genuine replacement parts for your appliance delivered to your door.

  • Genuine, manufacturer-approved parts
  • Fast next-day UK delivery
  • Secure checkout & easy returns