Solved
Hoover

Hoover Wdyn856 Washer Dryer, Dryer Not Working

PHPhippsey27
Asked over 12 years ago 2,797 views
0

Hi guys, in need of some help my washer dryer is not drying cloths or even getting warm when on thumble dryer mode, I have replace thermostat, pressure switch, element and the thing with 4 wires on it. The fan runs ok but only blowing cold air, cannot see what else could be wrong. Any help would be greatfull

Solution Summary

AI-generated from this discussion

This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.

Hoover Wdyn856 washer dryer not heating on drying cycle

The problem
A Hoover Wdyn856 washer dryer would not dry clothes and produced no heat on tumble dryer mode. The fan was reported to run, but only blew cold air.
Likely cause
The accepted reply said that, given the parts already replaced, the most likely remaining cause was a wiring or connection fault. A control unit fault preventing power being sent to the dryer circuit was mentioned only as a possibility, not a confirmed diagnosis.
What fixed it
No confirmed repair was documented. The accepted advice was that after replacing the thermostat, pressure switch, heating element and the four-wire component, the remaining likely area to investigate was wiring/connections rather than guessing further parts. Further diagnosis should be carried out by a suitably qualified appliance engineer.
Checks to try
  • Fan runs but only blows cold air
  • Thermostat replaced
  • Pressure switch replaced
  • Heating element replaced
  • A four-wire component was replaced
Parts or tools mentioned
  • Thermostat
  • Pressure switch
  • Heating element
  • Four-wire component

Safety: Do not keep replacing electrical parts by guesswork. Further diagnosis should be carried out by a suitably qualified appliance engineer.

Cause identifiedGenerated 16 Aug 2026 · AI summaries can make mistakes — read the full thread below.
Was this summary helpful?

1 Answer

Accepted Answer
0
WH
WhitegoodshelpVerified Engineer
Answered over 12 years ago

I have an help article for washer dryer not heating on dry cycle but you have replaced all the parts. Only connection faults are left unless by any chance the control unit is not giving power to the dryer but do not replace that as it's just another guess. Read the article just in case something helps.

Whitegoods Help — appliance repair expert and forum host.

Your Answer

Sign in to share your expertise and post an answer.