PROGRAM A HOOVER VISIONHD 41026072 ECU
Hi
I've just replaced the main PCB
41026072 in a hoover vision hd 8kg washer with a like for like unit (although a Candy)
im getting a E15 error code , i guess it is because the unit is unprogrammed , i believe you program it using a combination of buttons on the front of the machine , do you have details on how this is done PLEASE?
thank you jim
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Hoover VisionHD 41026072 replacement PCB shows E15 after fitting
- The problem
- After replacing the main PCB 41026072 in a Hoover Vision HD 8kg washing machine with a like-for-like Candy unit, the machine displayed error code E15. The poster believed the board was unprogrammed and asked for the front-panel button procedure to configure it.
- Likely cause
- The strongest supported explanation is that the replacement PCB required programming or configuration after installation. The accepted reply also warned that PCB replacement is often misdiagnosed, so the original fault may not have been confirmed.
- What fixed it
- No programming procedure was provided. The accepted advice was that if the PCB was supplied without setup instructions, the seller should have warned that configuration was needed, and some manufacturers only allow this to be done using engineer-only equipment. Further diagnosis should be carried out by a suitably qualified appliance engineer.
- Checks to try
- Main PCB 41026072 was replaced
- Machine displayed E15 after PCB replacement
- Replacement board was described as a like-for-like Candy unit
- Parts or tools mentioned
- Main PCB 41026072
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
1 Answer
Sorry I don't Jim. I always advise against replacing a PCB. Most of the time people have misdiagnosed it so even if it fits OK the fault often remains, but these days especially the manufacturers are making it much more difficult. If the PCB did not come with instructions for programming or setting up then it's useless selling it to the public. I would argue that whoever sold it should have warned it needed setting up or configuring. If there are no leaflets inside then the information is being held back for their engineers only. It used to be the case that spares companies would not sell programmers and PCBs to the public for these reasons. With some manufacturers these things even need setting up with laptops only supplied to their engineers.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hoover H-Wash & Dry 350. HELP !
1 answer • 2 replies
Hi I have just wasted 2 hours trying to get help for a hoover washing machine
1 answer • 2 replies
Hoover Otsein Next 3650T/1-37 error E03
1 answer • 2 replies
Hoover Washer stopping 1-2 minutes into cycle
1 answer • 3 replies
Hoover counterweight replacement
1 answer • 2 replies
Hoover Vision VHD 9143 ZD
1 answer • 11 replies
hoover VTS714 D21 wont spin
1 answer • 5 replies
Hoover VT 814D21-80 not working
1 answer • 4 replies
Hoover Visiontech washing machine fault
1 answer • 4 replies
Hoover wdyn 9646pg-30s shut down after 15 sec
1 answer • 11 replies