This machine although old has hardly been used and was working fine.
The drum does not move during any cycle, I have cleared the filter at the bottom kick plate.
I have checked the black hose on the bottom for blockages.
I have removed the top and checked for bad connections from the control block
I have checked that the motor cables are not lose.
The belt is intact and I can manually turn the drum
I don't know if the problem is the motor or the switch block or something else.
The machine fills and empties and blows hot air. The switch/Dial does not turn automatically as it should, when I manually turn it slightly it starts the next phase of the cycle but without the drum moving.
I don't know if the dial wont turn because the drum has not turned.
What could cause this?
Solution Summary
AI-generated from this discussion
This thread was marked as solved. Here's a summary of the problem and the fix, generated from the discussion below.
Hoover Wdm150 drum will not turn on any cycle
- The problem
- On a Hoover Wdm150, the drum did not move at any stage of the programme. The machine would fill, drain and produce hot air, but the programme dial did not advance by itself; it only moved to the next phase when turned manually, still without drum movement.
- Likely cause
- The discussion only supports a general diagnosis of a motor-related fault or another non-straightforward cause affecting drum drive. No exact failed component was confirmed.
- What fixed it
- No specific repair was confirmed. The accepted advice was that drum-not-turning faults can have several causes and, if the general checks already carried out do not identify it, the machine should be inspected by an engineer.
- Checks to try
- Filter at the bottom kick plate cleared
- Black hose at the bottom checked for blockage
- Top removed and connections from the control block checked
- Motor cables checked for looseness
- Drive belt confirmed intact
- Drum could be turned manually
- White bottle with black hose from the bottom rear of the drum removed and blown through, with clicking heard on and off
Safety: Further diagnosis should be carried out by a suitably qualified appliance engineer.
4 Answers
Motor not running could be many things, I have general advice on it here - http://www.whitegoodshelp.co.uk/washing-machine-not-spinning-drum-not-turning/
Need Professional Help or Spare Parts?
Hi, with a fault like that, if the article doesn't help it can't be anything straight forward so I have to advise getting an engineer. I covered everything I can think of to help in it.
Need Professional Help or Spare Parts?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hoover Wsahing Machine NOT filling with ENOUGH water
3 replies
Hoover H-Wash & Dry 350. HELP !
2 replies • Solved
Hi I have just wasted 2 hours trying to get help for a hoover washing machine
2 replies • Solved
Hoover Otsein Next 3650T/1-37 error E03
2 replies • Solved
Hoover Washer stopping 1-2 minutes into cycle
3 replies • Solved
Hoover counterweight replacement
2 replies • Solved
Hoover Vision VHD 9143 ZD
11 replies • Solved
hoover VTS714 D21 wont spin
5 replies • Solved
Hoover VT 814D21-80 not working
4 replies • Solved
Hoover Visiontech washing machine fault
4 replies • Solved
