I heard a little rattle yesterday but just thought it was possibly not sitting on the floor properly. Went in and had a look and noticed the machine had stopped 2 mins before it had completed it's cycle and the door lock light was repeatedly flashing.
There is no error codes, the drum spins fine and there is no blockages, so I took the rubber seal off to have a look at the door interlock system and noticed it wasn't attached with 2 screws from the front of the system, just looked like 2 plastic stumps.
I was hoping someone could tell me if I can replace this and how it would be attached, or if the interlock system is even the problem at all?
Any advice would be greatly appreciated folks.
2 Answers
Hi Scotty,
I've just been wrestling with the same problem on an oph714D/2-80.
I changed the door interlock and it hasn't fixed it so I'm thinking it's the PCBModule that's bad and it isn't heating up the bi-metal strip.
To remove the door interlock you must push the two little plastic lugs in and slide it inwards towards the centre of the drum. This releases the catches and the switch drops backwards into the machine.
Did you change the PCB and did it fix the problem?
Your Answer
Sign in to share your expertise and post an answer.
Related Questions
Hoover H Wash 500 unable to open filter door
2 replies • Solved
Hoover H wash 300 LINK Door Lock woes
1 reply • Solved
Hoover DXOA610AHFN-80 error E01 door interlock
1 reply • Solved
Hoover E07 error even after interlock replacement
1 reply
Hoover Select 1500 Not Starting Wash Programme After Previously Not Draining Due To Blockage
1 reply • Solved
Hoover Six 1100 Door Won't Open, At First..
1 reply • Solved
Hoover Door Hinge Broken
1 reply • Solved
Removing Door Seal On Hoover A2142 Washer
3 replies • Solved
Hoover Ac110 Door Hinge
3 replies • Solved
Hoover Wsahing Machine NOT filling with ENOUGH water
3 replies